HAAS 2000 Series garage doors stand up to the elements — insulating, dampening noise,and enhancing your building’s aesthetics at the same time. These insulated steel doors help increase energy savings with the polyurethane-foam cores.
Our doors are reinforced with roll-formed galvanized steel struts and double-end hinges, as required to meet windload specifications and to comply with ANSI A216.1 and NAGDM 102-1988.
Our three-tier, corrosion-resistant protective paint system is designed to resist even the most hostile weather conditions. Haas Door’s paint thickness is one of the highest in the industry. Most of the 2000 SERIES models are available in 10 colors.
HARD WORKING HARDWARE
The track is 2″ or 3″ galvanized steel, depending on door size, with bracket mount for wood jambs or continuous reverse mounting for steel jambs. For angle-mount track, door widths are 2″ wider than opening. Track rollers are 2″ or 3″ case-hardened inner and outer steel races with 10-ball pre-lubricated bearings. Hinges, brackets, and reinforced struts are hot-dipped galvanized steel. Fasteners are plated for maximum corrosion resistance.
Counterbalancing springs are torsion type, computer calibrated to match door load. This provides a 10,000-cycle life at the minimum; optional spring wires can achieve 25,000, 50,000 and 100,000 cycle requirements. Springs are wound from oil-tempered wire and mounted on a continuous cross header tube or solid shaft, as determined by torque load.
You can contact or one of our professional dealers for information on additional options, including: exterior cylinder locks, chain hoist operation, safety bottom brackets, and special lift clearance tracks (high lift, vertical lift, low headroom, and those that follow the roof line). Optional Aluminum Full View sections provide maximum light and visibility with available insulated glazing. Pass through doors are
also available on the 2000 SERIES.
2000 SERIES doors are 2″ thick. The calculated R-Value for this product is 17.66. Rigid vinyl extrusions with positive thermal breaks are used to eliminate metal-tometal contact, which limits the transfer of temperature. Tongue-and-groove construction and section joint seals at meeting rails provide optimum water and wind resistance.
A full-length, one-piece vinyl astragal retainer and flexible vinyl U-shaped weather-strip prevent infiltration of air, rain, snow and debris. The seal reduces impact shocks when the door is closed against concrete flooring.